Pulled Codes P0705 and P1702 – Performed Diagnostic – Test Sensor – Sensor Frozen To Shaft, Unable To Be Removed Without Damaging, Install New Sensor – Test Wiring OK – Clean and Inspect Related Connectors and Grounds – OK – Re Assemble and Test Drive – No Faults Returned At This Time – If Fault Returns Further Diagnostic Will Be Required, Likely Intermittent Wiring Concern
Shane E. gave our service a 5 star review on 4/2/2019
Found Failed R/F Lower Ball Joint, Wheel Hub Bearing Assy, and Integrated Wheel End, Found Failed L/F Upper Ball Joint and Integrated Wheel End – Ball Joints Both Had SEVERE Play, Both Front IWE Casings Broken – Unsafe For Road Use Remove and Replaced Failed Front End Components – Test Drove – OK 4wd Note As Inoperative – Front IWE Will Not Release Vacuum – Tested Solenoid, Failed – Remove and Replaced Faulty Solenoid, Re Test – OK
Performed Diagnostic – Unable To Pull Any Data From Module – No Communication – Performed Communication Diagnostics – Found Blown 10A ABS Control Module Fuse – Remove and Replaced – No Lights At This Time – If Light Returns/Fuse Blows Again Will Need To Perform Electric Diagnostics
Checked Tire Balance – Found Front Tires Out Of Balance – Performed Computerized High Speed Tire Balance To Front 2 Tires – Warranty
Johnny A. gave our service a 5 star review on 1/3/2019